On this post, we are going to share how to fix Nokia 2.4 (TA 1270) Device Corrupt problem. It is based on Mediatek MT6762 Helio P22 CPU with Android 10, Upgradable to Android 11. Here we use Infinity CM2 new version Tool i.e. CM2 MT2 V2.34.
👉Step by Step Guides:
- First Download Nokia 2.4 (TA 1270) latest Firmware,
- Extract Firmware using WinRar or 7-ZIP,
- Open CM2 MT2 Tool (use latest version),
- On Plaform/ Main Tab select 0_base ,
- Now Select Base_v2112 options,
- On right side you can find Global Settings,
- Make sure here you Un- tick on Meta and sSLA options,
- Power Off your Nokia 2.4 Phone,
- Remove back panel and Find Testpoint given below,
- Short two Point GND and testpoint using tweezer,
- Now, Insert USB Cable and Click on Identify/ Connect Tab,
- Make sure that you have install new version of Mediatek Preloader driver on your PC,
- After few Seconds you can see Boot Done,
- Before Flash we recommend you to take Backup of NVRAM,
- Go to Security tab and Choose Backup NVRAM options,
- Reconnect your phone using testpoint and after backup complete you may proceed to flash,
- Go to Flash tab and Load your Firmware,
- After that reconnect your Phone and USB cable using Testpoint,
- Click on flash button and wait until Flash Complete,
- If you face flashing Error then you have to Tick on Flash Format options,
- Flash Format erase all data including NVRAM also so we request to take backup first,
- Again repeat flash process and wait until Flash Complete,
- After Flash, Power ON your phone and Check IMEI no i.e. *#06#,
- If IMEI ok then no need to do more process,
- IF IMEI Null/ Blank then you have to write NVRAM backup file,
- To fix IMEI go to Security tab on your tool,
- Power off your Phone and reconnect using Testpoint,
- Choose options Write NVRAM and Select destination Folder and file,
- After NVRAM write Success your phone is Fully ready to use,
- Now Power ON your phone and setup it,
- If your phone ask previous Google ID or Lock and you don't know it then you can reset via tool or use bypass method,
- To remove FRP (Google ID) Open CM2 MT2 Tool,
- Go to Service Tab,
- Select [FRP] Reset Protection and Click on Reset Settings/ Format FS,
- Power off phone and Insert USB cable using Testpoint to detect,
- Wait until it show Format Ok: Reset Protection,
- That's all ! now your Nokia 2.4 is fully ready to use.
Note: By this way you can fix your Nokia 2.4 Phone. We try our best to help you in repairing fields. All solutions we provide here is tested before posting but, you have to perform this task with your own risk. If you found this post helpful then feel free to share it with your friends.