Header Ads

  • Breaking News

    Intex Aqua I- 4 Plus Flashing done without charging Port (Print Damage) jumper solution free ..

    Hello friends, today in this post we are going to share intex i-4 plus usb pinout/ charging ways. We can flash and repair mobile phone using this pinout if your phone usb connector is damaged.

    STEP BY STEP GUIDE:

    > Open/ Disassemble your Mobile Phone,

    > Remove all attached flex from Board,

    > Take one usb Cable and Cut it,

    > See USB Cable configuration,
       ( Short 4 no. pin and 5 no. pin if your mobile phone is not detected on your PC otherwise skip it)



    > Now Jumper all usb point as shown in given figures,


    [Solder Red wire to VCHG (+) and Black Wire to GND (-)]



    [ Now solder Green and White wire in DP(+) and DM(-) respectively]



    > Connect usb Cable into your Cmputer,

    > Open Sp flash tool,

    > Load Scatter file in tools,

    > Select Firmware Upgrade/ Download Only/ Format All + Download ,
         ( Format all + Download options damage IMEI of Phone)

    > After complete all process press Download Button,

    > Wait few minutes until you see Download OK Box,



    > That's all !!! Enjoy.


    Conclusion:
         We have received a intex i-4 plus phone with virus problem and try to flash but PC didn't detect usb Com port. we disassemble phone and found that there is no usb print all point are damaged only charging function support. Maybe another shopkeeper damage charging print when he/she gives mobile phones for repairing. Generally, most of the Mediatek based Phones have VCHG, DP, DM and GND point in board but we found there is no DP DM Point for usb connection. So that, we are sharing this solutions to help our gsm friends.


    Note: All solutions and file available in this site are free and doesn't contain any ads, if you face any problem then comment us below or message us. We try our best to solve your problem and if this post help you then Like, Share and Subscribe Us.

    Post Top Ad

    Post Bottom Ad